AQUASTEP UltravioletSterilizer
For use in the following applications: Installed in a hanging position or underneath aquarium tanks to kill disease causing micro-organisims. Also use inside pond filters or skimmers to kill free floating algae.

• Internal Step Design. Directs
  water back and forth across UV light
  tripling the contact time through
  the unit
• Ease of Replacement. Unique
  4 pin connector for easy bulb
  replacement without shutting down
  the system.
• Clear View Port. Allows visible
  light (no UV) to pass through and
  indicate bulb is operating
• Adjustable Clamp. Spring loaded
  clamp creates a snug fit to any
  aquarium or reservoir tank
• UV Bulb. Highest quality, pure hard
  quartz material allows maximum UV
  transmission and longer bulb life
• Compression Coupling
  and Gasket.
  Creates water tight seal at quartz
  sleeve and around ballast cord
• Electronic Ballast. 10W, 15W and
  25W high output UL listed ballast. (230V 50HZ ballast available).
• Versatile. Inlet and outlet at top for hang on and at bottom for below aquarium installations.
  Use inlet ports on each side to connect multiple units together for any size requirement
• Distribution Plate. Evenly distributes water into chamber.
• Plugs. Plug off inlet ports not in use. Can be removed to drain or clean unit.
• Design. Innovative design creates more volume area for increased contact time. Flat side allows snug fit to any aquarium or reservoir tank

• High Capacity. More capacity than any other
  make of equal height due to shape of chamber and
  step design
• Water Fall. Increases oxygen level by spreading
  out a thin sheet of gently falling water
• Adjustment Screws. Keeps unit level when
  installed in hanging position on tank
• Injection Molded Construction. Heavy duty,
  thick wall ABS injection molded parts. Built to last.
• Free Standing Base. Holds AquaStep in place for installations below or beside aquarium.